Wednesday, March 4, 2009

Hardware 1 x 0 Software Calibration

Yesterday I've got some progress on hardware. The piece of acrylic fit very nicely on the box, as seen on the picture above. The acrylic is folded piece, so the paper I used was very stretched on the midst of it.
Having setup all hardware (box, camera, touching surface), it was time to use my old friend ConfigApp. I've taken pictures of the process so I'll be able to keep track of progress, even though today's advance were nothing big. The screen shown above is the main calibration window. I posted it here wondering wheater my camera is bad or this is a common ajust that is needed to be done when entering the configapp. Anyone?
I carried on with the calibration. This is what I got: The image from the webcam fitting the entire screen.
The finger point out started!
Blobs were convincent. For me, not for ConfigApp. I've tried calibrating like 5 times, changing the position of the box, to get diferent shadows.

About shadows, does it shadow interfere that much on calibration?
From one of my yesterday's experience, I would say it shouldn't be a major problem.
Yes, I've done this. I've engaged on a laser calibration try-out. Response? None.

---

Is there any problem on the process and buttons I'm pressing while calibrating?
Here's what I do: Open the "ConfigApp". Press Enter. Resize the screen to fit in the entire area. Press C to start calibrating. Press and hold my finger on the spot of the upper left corner. Press "Space" key. Release my finger. Position my finger in the next green cross. Hold it. "Space" key again. And so on so far until the last one. After all that, press "ESC" and try to run "Smoke_Demo" or any other software in there. Nothing changes a bit.

ConfigApp has won this battle, but not the war.

No comments:

Post a Comment